I have mentioned a few times here that I have great plans for bringing water into the garden. This weekend has finally seen the first of two ponds started…
It is impossible (for me anyway!) to make accurate plans for our garden. Every thing is curved, or at a funny angle, or non-definite in its placement such as the hedge boundaries. Instead I sketch out ideas roughly to scale, and then try to translate them onto what looks right on the ground by laying ropes on the grass. So it was with the pond. We now have an outline of the bed it will sit in, an outline of the water area, and some kind of a plan for depths. However it is only with a lot of head-scratching that we have managed the last part.
The first test trench was dug about a month ago, straight across the middle of where we thought we wanted the pond, which will be roughly kidney-shaped. It was dug a spade’s width at the top, down to two foot six or so which I understand is the minimum depth for a wildlife pond. The good news was that it was topsoil all the way down, so it will be very easy to use what we dig out elsewhere in the garden. (Unexpected, given other areas are sandstone and clay within a spade’s depth or less; plants there will be glad of some more decent soil.) Also it has sufficient clay to hold the sides together even if they are cut steep – meaning we should be able to reach our required depth despite the small size. On the bad side however, digging was made easier by the extraction of eight or nine bricks at the bottom of the trench – the removal of which turned the hole into an old-fashioned lightbulb shape. Since we have already dug out 4,500 bricks in our garden, which is only the size of a singles tennis court, we really didn’t feel the need for any more! (They proved very useful for our extension as they match exactly…) Worse, we found the edge of an old path about a foot down, made of modern slippery pavers laid onto a very thick (8-10”) bed of concrete. Not so helpful when its line threatens to cut right across the proposed pond. It did, however, explain why the grass down the middle of the garden always went brown in summer.
This weekend the plan was to decide where the two ends of the pond would be within the ‘pond bed’, so that I could measure up and order such things as liner, edging, cobbles etc. Marking out with the aid of a rope laid on the ground, no problem even with M’s help. Second test hole to check the buried path, not so great. The path sloped upwards towards ground level, rapidly becoming too shallow to use as a marginals shelf at barely six inches below anticipated water level, and the concrete base turned out to be three foot wide. In four foot wide water this wasn’t too helpful.
So after some more thinking, we have finally decided to: use the first section of the path we discovered as a marginals shelf somewhere in the middle of the pond; make the far end of the pond deep instead of shallow; use the shallowest bit of concrete as base for the cobbled area; and cut a hole across the middle of the path where it really can’t be avoided in order to give a second deep area.The photo shows the deep trench in the foreground with some of the bricks and other rubble we dug out, a row of pavers forming the edge of the path, and a wide area of concrete, pavers removed. There are a few bits of grass and soil left to remove within the pond area… Top right is the corner of the base for my new sanctuary space, from where I plan to watch the rain bouncing up from the surface of the pond, frogs diving amongst the plants, and a pourover gently keeping the pond topped up with rainwater.
Did I mention there will eventually be a stream running into this pond? Meaning that the water also needs to be deep enough at the top end for a pump for when it isn’t raining? Raising the pond would have been an alternative solution – but then it would be too high for the stream to actually flow into it!
I am continuing to trust that my crazy, ambitious plans are all capable of being realised and will work!